FPV Drone Service and Repair
Dialed-in repairs, fast turnarounds, and builds that fly locked-in for freestyle, racing, and long-range.
We only use your details for service communication and tax invoicing.
Pay the listed labour amount online to reserve your repair slot.
Parts are billed separately after bench inspection and approval.
Choose your service plan
Fixed labour pricing, parts billed separately.
- Visual inspection (frame, arms, wiring)
- Motor spin and ESC beep test
- Battery connector and XT check
- RX and VTX power test
- Basic Betaflight or ArduPilot check
- Short-circuit test
You will receive a tax invoice after service confirmation.
- Motor replacement (up to 1 motor)
- Prop replacement
- Up to 8 solder joints
- RX rebind (ELRS, Crossfire, FrSky)
- ESC calibration
- Failsafe verification
You will receive a tax invoice after service confirmation.
- Up to 2 motor replacements
- Moderate soldering (up to 15 joints)
- VTX table setup and power unlock
- Receiver configuration
- Motor direction and RPM filter check
- Bench test plus short hover test
You will receive a tax invoice after service confirmation.
- Full Betaflight tune
- PID and filter optimization
- RPM filtering and motor balance check
- Camera angle optimization
- Blackbox analysis (if supported)
- RSSI and link quality tuning
You will receive a tax invoice after service confirmation.
- ArduPilot, iNav, or Betaflight long-range setup
- GPS and compass calibration
- RTL, failsafe, and geofence setup
- Li-ion voltage and current tuning
- Cruise and loiter optimization
- Antenna placement check
You will receive a tax invoice after service confirmation.
- Full teardown and cleaning
- ESC or FC replacement (labour)
- Pad repair and jumper wiring
- Full re-wire and re-solder
- Firmware flash and config restore
- Stress test and final verification
You will receive a tax invoice after service confirmation.
- Complete frame build
- Full wiring and soldering
- FC, ESC, RX, and VTX install
- Firmware setup
- Basic tune
- Configuration handover
You will receive a tax invoice after service confirmation.
- Custom part selection assistance
- Advanced wiring and power management
- ArduPilot tuning
- Failsafe and safety configuration
- Documentation and support
You will receive a tax invoice after service confirmation.
- Prices are labour only.
- Spare parts billed separately at actuals.
- No responsibility for old or crash-damaged electronics.
- Customer approval required before part replacement.
- No warranty on crash-damaged electronics.
Share your build list, symptoms, and crash notes for faster turnaround.